Description
O2 Sensor Removal Optimizer Victory
LLoydz O2 sensor removal Optimizer for 2016 & 2017 Victory Motorcycles (excluding Octane)
The Optimizer is Basically a resistor that plugs in line to trick the heater sensors and keeps the check engine light from coming on your Victory Motorcycle when using bungs.
Oxygen Sensor Bypass used when installing a programmer and you want to bypass the Oxygen sensor to get optimum performance out of your Victory Motorcycle.
These plug into your wiring harness instead of your O2 sensors. On the earlier Victory models you could just unplug your O2 sensors and not cause the check engine light to come on or a service code now with the 2016 and up, Victory changed the O2 sensor and if you just unplug them, the ECU throws a code.
These plugs remedy that issue with no wires cut.
Sold as a Pair of O2 Sensor Block Off's specifically for the 2016 or select the set for 2017 Victory Motorcycles
2016 950099030 (old part #) 303-1 (new part #)
2017 950099034 (old part #) 304-1 (new part #)
Be sure to check out our O2 sensor bungs for the exhaust!
Power Commander and most programmers now stopped including these sensors and there is no way to get optimal performance
from a Power Commander 5 without using these bypass plugs because the computer will not allow the bike to run in the heat range needed to produce the most horse power possible.
A good customer just sent me this and I wanted to share it:
I just installed the 02 sensor bypass! Wow what a difference! Better power and response! The heat generated is about half of what it was before and the increased torque is extremely satisfying! Plus I have to say at this point my fuel mileage has actually increased a fair bit even with my very heavy right hand, so really, you are going to save money. This is the way it should have come from the factory.
O2 Sensor Removal Optimizer Victory
